the controle tones would go over the left-audio and the sound over the right, you'd have to use an external speaker I guess since the phone's internal speaker is turned off when you plug in an audio jack. like Caine when he was turned into a robot in RoboCop 2 :D Doing the Skype conversion, you could make it 2-way communications. ![]() What also would be cool is if you could use the phone in upright (portrait) position using the front camera and display a face animation on the screen while the spider-bot is walking around. After tightening, check that no copper wire strands are shorting together.ĭouble check all your connections and make sure there are no shorts (connections between wires) before inserting batteries. Insert the stripped wires into the holes as shown, and tighten the screw above the hole using a small flat head screwdriver. Reversing the connections can either damage the ADMCB or cause the robot to move incorrectly.Ĭonnecting the wires to the ADMCB is easy using the flat head screw terminals. It's very important that all the wires are connected to the ADMCB EXACTLY as shown. You can learn more about the ADMCB here: The ADMCB decodes the tones into forward and reverse voltages to the motors. ![]() The Android device will control the motors in the Hexbug Spider by sending tones through the headphone jack to the ADMCB. The EMGRobotics Audio Dual Motor Controller Board (ADMCB) connects to the motors in the Hexbug Spider, the battery holder, and the headphone jack on the Android device.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |